Prepare the substrate and the panels
Ensure that the substrate is wind-tight, level, and stable—this can be a timber or steel subframe.
Install a ventilated secondary structure with an air gap behind the panels.
Adjust the panels in length or width as required; use a circular saw or jigsaw with a fine-toothed blade to achieve a clean cut.
If you wish to protect the surface during cutting, apply painter’s tape along the cut line.
Fasten the panels with façade screws.
Use Nordic Outdoor PRO façade screws, designed for both timber and steel constructions.
Drive the screws through the slats at the selected pre-drilled points—or between the slats—to keep them discreet.
Be sure to follow the screw pattern in the installation guide for a uniform look and optimal fixation.
Adjust and check
After each installation, you should check that lines and spacing are consistent. Use a spirit level and spacers if necessary so that all panels align correctly—both horizontally and vertically.
Install the next panel
Continue with the next panel, ensuring the joints are tight and harmonious.
Measure the final panel precisely to achieve a clean, professional finish.
TIP!
To prevent insects from getting behind the panels, you can install insect mesh at the top and bottom of the structure.
